Yeti 5L (2009 - 2017)

Name: Rear Subframe Front Mounting Bush Product Notes: This bush fits 4 wheel drive models only up to 28.5.2012. Weight: 1655Fitting Instructions

Name: Rear Subframe Rear Mounting BushProduct Notes: This bush uses our Purple 80A durometer material with bonded supporting washers for strengthening and a bespoke end face design to reduce noise transmission to the cabin, whilst maintaining durability and subframe location. Weight: 1036Fitting Instructions

Name: Rear Subframe Rear Mounting BushProduct Notes: This bush uses our Black 95A durometer material with bonded supporting washers for strengthening and a bespoke end face design to reduce noise transmission to the cabin, whilst maintaining durability and subframe location. Weight: 1036Fitting Instructions

Name: Rear Subframe Rear Mounting Bush Product Notes: This bush fits 4 wheel drive models only up to 28.5.2012. Weight: 1400Fitting Instructions

Name: Rear Tie Bar to Chassis Front Bush Product Notes: Weight: 762

Name: Rear Upper Wishbone Outer Bush Product Notes: Weight: 388 Fitting Instructions

Name: Rear Upper Wishbone Outer Bush Camber AdjustableProduct Notes: PFR85-513G Rear Upper Wishbone Outer Bush is a camber adjustable version of our existing PFR85-513 Rear Wishbone Outer Bush for a variety of VAG models. Made in our Black 95A durometer material and supplied with a CNC-machined offset-bore sleeve and adjusting spanner, it offers a range of up to +/- 1.0 of on-car camber adjustment at the rear suspension knuckle. Weight: 732Fitting Instructions

Name: Rear Upper Wishbone Outer Bush Camber AdjustableProduct Notes: PFR85-513G Rear Upper Wishbone Outer Bush is a camber adjustable version of our existing PFR85-513 Rear Wishbone Outer Bush for a variety of VAG models. Made in our Black 95A durometer material and supplied with a CNC-machined offset-bore sleeve and adjusting spanner, it offers a range of up to +/- 1.0 of on-car camber adjustment at the rear suspension knuckle. Weight: 731Fitting Instructions

Name: Transmission Mount InsertProduct Notes: Designed to fill the voiding in the OE rubber mount, it smooths out gear changes by stiffening and supporting the often perished rubber bush, which is common for failure on tuned vehicles. This will provide a more precise and settled transmission response during acceleration and deceleration. A small increase in NVH, usually at idle, should be expected when stiffening the connecting mount between the engine/transmission and chassis. The harder the material used, the greater the NVH transmitted especially on diesel vehicles. The stock transmission and upper engine mounts have always been a problem on these vehicles. The rubber perishes and splits, allowing for excessive engine movement. The answer until now has been to replace with new standard rubber mounts or fit expensive aftermarket mounts that are generally prone to excessive levels of NVH transmission. PFF85-530 is an intermediate solution from Powerflex. Weight: 300Fitting Instructions