Orlando J309 (2011- 2018)

Name: Front Control Arm Front BushProduct Notes: Weight: 445

Name: Front Control Arm Rear BushProduct Notes: Weight: 823Fitting Instructions

Name: Front Engine Mounting InsertProduct Notes: Fits 1.8 and 2.0L petrol models. For diesel-engined vehicles use PFF80-1420R. This part is designed to fit into the original voided rubber mount which degrades and softens over time, allowing for excessive movement of the engine and premature failure. A small increase in NVH, usually at idle, should be expected when stiffening the connecting mount between the engine/transmission and chassis. The harder the material used, the greater the NVH transmitted. Weight: 382

Name: Front Engine Mounting Insert (Diesel)Product Notes: Fits 1.8 and 2.0L diesel models. For petrol-engined vehicles use PFF80-1420. This part is designed to fit into the original voided rubber mount which degrades and softens over time, allowing for excessive movement of the engine and premature failure. A small increase in NVH, usually at idle, should be expected when stiffening the connecting mount between the engine/transmission and chassis. The harder the material used, the greater the NVH transmitted. Weight: 382

Name: PowerAlign Camber Bolt Kit (12mm x 60mm)Product Notes: Our PowerAlign camber bolts replace the original upper bolt on suspension struts with a two-bolt fixing to the knuckle, one positioned above the other, allowing up to +/- 1.75 degrees of adjustment. This kit contains 2 camber bolts, tab washers and nuts. Why not add our Magnetic Camber Gauge to your tool kit so that you can make pit garage adjustments to your suspension using PowerAlign Camber Bolts. Bush Size: M12 x 60mmWeight: 189Fitting Instructions

Name: Rear Beam Mounting BushProduct Notes: PFR80-1410 fits vehicles with Watt's linkage. For vehicles without Watt's linkage, please use PFR80-1310. Weight: 956

Name: Rear Engine Mounting InsertProduct Notes: This part is designed to fit into the original voided rubber mount which degrades and softens over time, allowing for excessive movement of the engine and premature failure. Recommended for petrol models. For diesel models use PFF80-1421R. Weight: 339

Name: Rear Engine Mounting Insert Diesel Product Notes: This part is designed to limit movement of the original voided rubber mount whilst being mindful of vibration transmitted to the vehicle and is recommended for diesel models. Weight: 339

Name: Rear Panhard Rod Outer BushProduct Notes: Weight: 358